ELECTRONIC SHIFT LEVER SYSTEM > HOW TO PROCEED WITH TROUBLESHOOTING |
| 1.VEHICLE BROUGHT TO WORKSHOP |
| |||||
| 2.INSPECT BATTERY VOLTAGE |
| |||||
| 3.CHECK COMMUNICATION FUNCTION OF MULTIPLEX COMMUNICATION SYSTEM (BEAN)* |
Use the Techstream to check if the Multiplex Communication System (MPX) is functioning normally.
| Result | Proceed to |
| MPX DTC is not output | A |
| MPX DTC is output | B |
|
| ||||
| |||||
| 4.CHECK COMMUNICATION FUNCTION OF CAN COMMUNICATION SYSTEM* |
Use the Techstream to check if the CAN communication system is functioning normally.
| Result | Proceed to |
| CAN DTC is not output | A |
| CAN DTC is output | B |
|
| ||||
| |||||
| 5.CHECK FOR DTC* |
Check for DTCs and note any codes that are output.
Delete the DTC.
Recheck for DTCs. Based on the DTCs output above, try to force output of the electronic shift lever system DTC by simulating the operation indicated by the DTC.
| Result | Proceed to |
| DTC is not output | A |
| DTC is output | B |
|
| ||||
| |||||
| 6.PROBLEM SYMPTOMS TABLE |
| Result | Proceed to |
| Fault is not listed in problem symptoms table | A |
| Fault is listed in problem symptoms table | B |
|
| ||||
| |||||
| 7.OVERALL ANALYSIS AND TROUBLESHOOTING* |
Data List / Active Test (Click here)
Terminals of ECU (Click here)
| |||||
| 8.REPAIR OR REPLACE |
|
| ||||
|---|---|---|---|---|---|