Home › BODY ELECTRICAL › DOOR LOCK › WIRELESS DOOR LOCK CONTROL SYSTEM (w/o Smart Key System)

WIRELESS DOOR LOCK CONTROL SYSTEM (w/o Smart Key System) > HOW TO PROCEED WITH TROUBLESHOOTING

for Preparation Click here


HINT:
  1. Use these procedures to troubleshoot the wireless door lock control system.
  2. *: Use the Techstream.



1.VEHICLE BROUGHT TO WORKSHOP

    NEXT


    2.INSPECT BATTERY VOLTAGE

      Standard voltage:
      11 to 14 V

      If the voltage is below 11 V, recharge or replace the battery before proceeding

    NEXT


    3.INSPECT COMMUNICATION FUNCTION OF LARGE-SCALE MULTIPLEX COMMUNICATION SYSTEM (BEAN)*
    1. Using the Techstream, check if the Multiplex Communication System (MPX) is functioning normally (Click here).
      Result: 
      Result
      Proceed to
      MPX DTC is not output
      A
      MPX DTC is output
      B



    B.
    Go to MULTIPLEX COMMUNICATION SYSTEM
    A


    4.CHECK FOR DTC*
    1. Check for DTCs and note any codes that are output.

    2. Delete the DTC.

    3. Recheck for DTCs. Try to prompt the DTC by simulating the original activity that the DTC suggests.
      Result: 
      Result
      Proceed to
      DTC does not reoccur
      A
      DTC reoccurs
      B



    B.
    Go to step 7
    A


    5.PROBLEM SYMPTOMS TABLE
      Result: 
      Result
      Proceed to
      Fault is not listed in problem symptoms table
      A
      Fault is listed in problem symptoms table
      B


    B.
    Go to step 7
    A


    6.OVERALL ANALYSIS AND TROUBLESHOOTING*
    1. Operation check (Click here)

    2. DATA LIST / ACTIVE TEST (Click here)

    3. Terminals of ECU (Click here)

    4. Inspection (Click here)


    NEXT


    7.ADJUST, REPAIR OR REPLACE

      NEXT


      8.CONFIRMATION TEST

        NEXT

        END