Home › SUSPENSION & AXLE › TIRE AND WHEEL › TIRE AND WHEEL SYSTEM

TIRE AND WHEEL SYSTEM > INSPECTION

for Preparation Click here



1. INSPECT TIRE
  1. Check the tires for wear and proper inflation pressure.

    Standard cold tire inflation pressure:
    Tire Size
    Front Pressure
    Rear Pressure
    185/65R15 86S
    240 kPa (2.4 kgf/cm2, 35 psi)
    230 kPa (2.3 kgf/cm2, 33 psi)
    195/55R16 86V
    240 kPa (2.4 kgf/cm2, 35 psi)
    230 kPa (2.3 kgf/cm2, 33 psi)



    C050798E01
  1. Using a dial indicator, check the tire runout (vertical and horizontal).

    Standard tire runout:
    1.4 mm (0.055 in.) or less



2. ROTATE TIRE


F008740E01

HINT:
Rotate tires as shown in the illustration.



3. INSPECT WHEEL BALANCE


    C080976E01
  1. Check and adjust the off-the-car balance.

  1. If necessary, check and adjust the on-the-car balance.

    Standard imbalance after adjustment:
    8.0 g (0.018 lb) or less



4. INSPECT BEARING BACKLASH
  1. Inspect the front bearing backlash (Click here).



5. INSPECT FOR AXLE HUB DEVIATION
  1. Inspect for front axle hub deviation (Click here).



6. INSPECT BEARING BACKLASH
  1. Inspect the rear bearing backlash (Click here).



7. INSPECT FOR AXLE HUB DEVIATION
  1. Inspect for rear axle hub deviation (Click here).