Home › BRAKE › BRAKE CONTROL › SKID CONTROL SENSOR

SKID CONTROL SENSOR > INSTALLATION

for Preparation Click here



1. INSTALL SKID CONTROL SENSOR
  1. Wipe off sealant attached to the sensor's fitting surface with white gasoline.

    NOTICE:
    Prevent foreign matter from attaching to the sensor rotor.



    F007318E02
  1. Install a new sensor to the rear axle hub and bearing. The sensor connector should be placed in the lowest position.

    HINT:
    The narrow side of the rear axle hub and bearing should be placed below.



    F008658E04
  1. Using SST and a press, press the speed sensor so that it becomes flush with the rear axle hub and bearing.

    SST
    09214-76011  

    NOTICE:
    1. Do not use a hammer on the sensor.
    2. Check that there is no foreign matter such as iron chips on the sensor's detecting portion.
    3. Slowly press the sensor in straight.



2. INSTALL REAR AXLE HUB AND BEARING ASSEMBLY
  1. Install the axle hub and bearing LH on the axle beam with the 4 bolts.

    Torque:
    61 N*m{ 622 kgf*cm , 45 ft.*lbf }



3. INSTALL SKID CONTROL SENSOR WIRE


4. INSTALL REAR BRAKE DRUM SUB-ASSEMBLY
  1. Aligning the matchmarks, install the rear brake drum.



5. INSTALL REAR WHEEL

Torque:
103 N*m{ 1,050 kgf*cm , 76 ft.*lbf }



6. INSPECT REAR WHEEL ALIGNMENT
  1. Inspect the rear wheel alignment (Click here).



7. CHECK ABS SPEED SENSOR SIGNAL
  1. Check the speed sensor signal (Click here).