Home › BRAKE › BRAKE CONTROL › BRAKE CONTROL POWER SUPPLY

BRAKE CONTROL POWER SUPPLY > INSTALLATION

for Preparation Click here



1. INSTALL NO. 1 BRAKE CONTROL POWER SUPPLY BRACKET


2. INSTALL NO. 2 BRAKE CONTROL POWER SUPPLY BRACKET


3. INSTALL NO. 3 BRAKE CONTROL POWER SUPPLY BRACKET


4. INSTALL BRAKE CONTROL POWER SUPPLY ASSEMBLY


    C127951
  1. Install the brake control power supply with the 4 bolts.

    Torque:
    19 N*m{ 194 kgf*cm , 14 ft.*lbf }

  1. Connect the brake control power supply connector.



5. INSTALL DECK TRIM SIDE PANEL ASSEMBLY RH
  1. Install the deck trim side panel RH (Click here).

    HINT:
    Refer to the procedures from the installation of the deck trim side panel assembly RH up until the installation of the rear door scuff plate RH.



6. INSTALL REAR SEAT CUSHION ASSEMBLY

NOTICE:
When installing the seat cushion, make sure the seat belt buckle is not under the seat cushion.



    B132601E01
  1. Attach the seat cushion's rear hook to the center hinge.

  1. Insert the inner belts through the slits on the seat cushion.



    B132602
  1. Attach the seat cushion's 2 front hooks to the vehicle body.

  1. Confirm that the seat cushion is firmly installed.



7. CHECK AND CLEAR DTC
  1. Check and clear the DTC (Click here).