Home › BRAKE › BRAKE CONTROL › YAW RATE AND DECELERATION SENSOR

YAW RATE AND DECELERATION SENSOR > INSTALLATION

for Preparation Click here



1. INSTALL YAW RATE SENSOR


    F046182E01
  1. Install the sensor with the 2 bolts.

    Torque:
    19 N*m{ 194 kgf*cm , 14 ft.*lbf }

  1. Connect the sensor connector.



2. INSTALL REAR CONSOLE BOX SUB-ASSEMBLY


B074083E03
  1. Install the console box with the 2 screws and 2 bolts.



3. INSTALL CONSOLE BOX CARPET


4. INSTALL CONSOLE BOX POCKET


5. INSTALL UPPER CONSOLE PANEL SUB-ASSEMBLY


B074082E03
  1. Install the instrument panel cup holder with the 4 screws.



    B074080E03
  1. Attach the 4 clips and 2 claws to install the console panel.



6. PERFORM YAW RATE SENSOR ZERO POINT CALIBRATION
  1. Perform the yaw rate sensor zero point calibration (Click here).



7. CHECK AND CLEAR DTC
  1. Check and clear the DTC (Click here).