POWER STEERING SYSTEM > ON-VEHICLE INSPECTION |
| 1. CHECK STEERING EFFORT (TORQUE) |
Stop the vehicle on a level, paved road and align the wheels straight ahead.
Disconnect the cable from the negative (-) battery terminal.
Remove the steering pad (Click here).
Connect the cable to the negative (-) battery terminal.
Using a torque wrench, check if the steering wheel set nut is properly tightened.
Turn the power switch ON (IG) (the engine and the hybrid system are not operated) so that power steering is ready to operate.
![]() |
Turn the steering wheel 90 degrees to the right and check steering effort (torque) while turning. Check in the opposite direction using the same procedure.
Align the front wheels straight ahead.
Disconnect the cable from negative (-) battery terminal.
Install the steering pad assembly (Click here).
Connect the cable to the negative (-) battery terminal.
Clear the DTCs (Click here).
Perform initialization (Click here).
Inspect the airbag warning light (Click here).
| 2. CHECK STEERING WHEEL FREE PLAY |
Turn the power switch ON (IG) so that power steering is ready to operate.
Align the wheels straight ahead.
Gently turn the steering wheel right and left with your finger and check the steering wheel free play.