Home › BODY › ENGINE HOOD / DOOR › HOOD

HOOD > INSTALLATION

for Preparation Click here


HINT:
A bolt without a torque specification is shown in the standard bolt chart (Click here).



1. INSTALL HOOD LOCK CONTROL CABLE ASSEMBLY
  1. Install the cable.



  1. Connect the cable clamps as shown in the illustration.


    B075134E01

  1. Install the front fender liner (Click here).

  1. Remove the front bumper cover (Click here).



2. INSTALL HOOD INSULATOR
  1. Install the insulator with the 6 clips.



3. INSTALL HOOD SUPPORT ROD
  1. Install the retainer and holder.

  1. Install the rod.



4. INSTALL HOOD LOCK ASSEMBLY


B076899E01
  1. Connect the hood lock control cable.

  1. Install the lock with the 3 bolts.

    Torque:
    8.0 N*m{ 82 kgf*cm , 71 in.*lbf }

  1. Adjust the hood lock (Click here).