GENERATOR CABLE > REMOVAL |
| 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| 2. REMOVE SERVICE PLUG GRIP |
Remove the service plug grip (Click here).
| 3. REMOVE ENGINE UNDER COVER LH |
| 4. REMOVE ENGINE UNDER COVER RH |
| 5. DRAIN COOLANT (for Inverter) |
Drain coolant (Click here).
| 6. REMOVE FRONT COWL TOP PANEL OUTER SUB-ASSEMBLY |
Remove the cowl top front panel .
| 7. REMOVE INVERTER WITH CONVERTER ASSEMBLY |
Remove the inverter with converter (Click here).
| 8. REMOVE GENERATOR CABLE |
![]() |
Check that there is no voltage.
Remove the 4 bolts and power cable cover.
![]() |
Remove the 2 bolts from the generator cable.
![]() |
Inspect the voltage between each of the 3 phase AC terminals (U to V, V to W, U to W) and body ground using the Toyota electrical tester.
![]() |
Remove the 3 bolts and generator cable.