Home › SUSPENSION & AXLE › TIRE AND WHEEL › TIRE PRESSURE WARNING SYSTEM

DTC    C2176/76    Receiver Error

for Preparation Click here


DESCRIPTION

When the tire pressure warning ECU is detected to ECU internal error, DTC C2176/76 is stored.

DTC Code
DTC Detection Condition
Trouble Area
C2176/76
Malfunction in the tire pressure warning ECU internal circuit.
Tire pressure warning ECU

INSPECTION PROCEDURE

NOTICE:
  1. When replacing the tire pressure warning ECU, read the IDs stored in the old ECU using the Techstream and write them down before removal.
  2. It is necessary to perform initialization (Click here) after registration (Click here) of the transmitter IDs into the tire pressure warning ECU after the ECU has been replaced.

1.CHECK DTC (C2176/76)
  1. Clear the DTC (Click here).

  1. Turn the power switch off.

  1. Turn the power switch on (IG) and check for DTC (Click here).

    OK:
    DTC C2176/76 is not output.



NG
REPLACE TIRE PRESSURE WARNING ECU (Click here)
OK

END