Home › General › INTRODUCTION › REPAIR INSTRUCTION › 2011.12–2015.11
RM2170E _V1 General _056999 INTRODUCTION _0277801 REPAIR INSTRUCTION D

INTRODUCTION  REPAIR INSTRUCTION  INITIALIZATION  


PROCEDURES NECESSARY WHEN AUXILIARY BATTERY TERMINAL IS DISCONNECTED/RECONNECTED


Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed See page
Unlock back door Back door opener (Click here)


PROCEDURES NECESSARY WHEN ECU OR OTHER PARTS ARE REPLACED


Replacement Part Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed See page
·

Throttle body with motor assembly

·

Engine assembly

·

Cylinder head sub-assembly

·

Camshaft (for intake or exhaust camshaft)

·

Camshaft timing gear assembly

·

Piston or piston ring

·

Mass air flow meter sub-assembly

·

Fuel injector assembly

·

Fuel pump with filter assembly

·

Air fuel ratio sensor

·

Engine coolant temperature sensor

·

Spark plug

·

Ignition coil assembly

·

EGR valve assembly

·

Air intake system parts

·

Exhaust system parts

·

Knock control sensor


Inspection after repair Poor idle, engine starting, etc (Click here)
Brake booster with master cylinder assembly
·

Initialization and calibration of the linear solenoid valve

·

Yaw rate and acceleration sensor zero point calibration


·

ABS warning light illumination

·

Brake warning light/yellow (minor malfunction) illumination

·

Slip indicator light illumination

·

VSC disable or malfunctioning


(Click here) for Initialization
(Click here) for Calibration
·

Brake pedal stroke sensor assembly

·

Brake pedal


·

Clearing stored linear solenoid valve calibration data

·

Initialization and calibration of the linear solenoid valve


(Click here)
Yaw rate and acceleration sensor (air bag sensor assembly)
·

Clearing zero point calibration data

·

Yaw rate and acceleration sensor zero point calibration


(Click here)
Power steering ECU assembly
·

Torque sensor zero point calibration

·

Assist map writing


·

P/S warning light comes on

·

EPS control


(Click here)
Electric power steering column sub-assembly Torque sensor zero point calibration Steering effort is different between turning steering wheel to left and right
·

Certification ECU (smart key ECU assembly)

·

Steering lock ECU (steering lock actuator assembly)

·

ID code box (immobiliser code ECU)

·

Power management control ECU (Hybrid vehicle control ECU)

·

Electrical key transmitter sub-assembly


Code registration (Engine immobiliser system)
·

Wireless door lock control system

·

Smart entry and start system

·

Hybrid control system start

·

Steering lock system


See the Service Bulletin for the registration method
·

No. 1 air conditioning radiator damper servo sub-assembly

·

No. 2 air conditioning radiator damper servo sub-assembly

·

No. 1 blower damper servo sub-assembly


Initialization servo motor (Air conditioning system) DTCs are output (Click here)
·

Door window regulator assembly

·

Power window regulator motor assembly

·

Door glass

·

Door glass run


Initialize power window control system
·

Auto up/down function

·

Jam protection function

·

Operation function after power switch is turned off


(Click here)
·

Headlight leveling ECU assembly

·

Rear height control sensor sub-assembly


Perform headlight leveling ECU initialization Automatic headlight beam level control function (Click here)