Home › Engine / Hybrid System › 1NZ-FXE (ENGINE CONTROL) › ENGINE COOLANT TEMPERATURE SENSOR › 2011.12–2014.12
RM2170E _51 Engine / Hybrid System _057003 1NZ-FXE ENGINE CONTROL _0277918 ENGINE COOLANT TEMPERATURE SENSOR A

1NZ-FXE ENGINE CONTROL  ENGINE COOLANT TEMPERATURE SENSOR  INSTALLATION  


PROCEDURE

Hide 89422 1.INSTALL ENGINE COOLANT TEMPERATURE SENSOR

a.

Install a new gasket to the engine coolant temperature sensor.


b.

Using a union nut wrench 19 mm, install the engine coolant temperature sensor.

Torque:
20 N*m (200 kgf*cm, 14 ft.*lbf)

NOTICE:

Use the torque value compensation formula to calculate the torque value for use when a torque wrench is combined with a tool such as a union nut wrench (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


HINT:

Perform "Inspection After Repair" after replacing the engine coolant temperature sensor (See page Engine / Hybrid System>1NZ-FXE (ENGINE CONTROL)>SFI SYSTEM (w/o Canister Pump Module)>INITIALIZATION).



c.

Connect the engine coolant temperature sensor connector.


d.

Connect the wire harness.


Hide G9200 4.INSTALL INVERTER WITH CONVERTER ASSEMBLY