Home › Engine / Hybrid System › 1NZ-FXE (ENGINE CONTROL) › KNOCK SENSOR
RM2170E _51 Engine / Hybrid System _057003 1NZ-FXE ENGINE CONTROL _0277919 KNOCK SENSOR A

1NZ-FXE ENGINE CONTROL  KNOCK SENSOR  INSTALLATION  


PROCEDURE

Hide 89615 1.INSTALL KNOCK SENSOR

a.
A267412E01
2.354,0.512 2.522,0.661 0.168,0.148 10 *a 2.313,1.228 2.481,1.377 0.168,0.148 10 *b 2.59,1.227 2.758,1.376 0.168,0.148 10 *c

Install the knock sensor with the bolt as shown in the illustration.

Text in Illustration
*a Front of Engine
*b 10°
*c 30°

Torque:
20 N*m (204 kgf*cm, 15 ft.*lbf)

NOTICE:

Make sure that the knock control sensor is in the correct position.



b.

Connect the knock sensor connector.