Home › Engine / Hybrid System › 1NZ-FXE INTAKE / EXHAUST › INTAKE MANIFOLD
RM2170E _51 Engine / Hybrid System _057008 1NZ-FXE INTAKE / EXHAUST _0277968 INTAKE MANIFOLD A

1NZ-FXE INTAKE / EXHAUST  INTAKE MANIFOLD  INSTALLATION  


PROCEDURE

Hide 17111 1.INSTALL INTAKE MANIFOLD

a.

Install a new No. 1 intake manifold to head gasket to the intake manifold.


b.

Install the intake manifold insulator with the bolt.

Torque:
10 N*m (102 kgf*cm, 7 ft.*lbf)


c.

Connect the ventilation hose.


d.

Temporarily install the intake manifold and intake manifold stay with the 5 bolts and 2 nuts.


e.
A268526E03
2.552,0.031 2.729,0.188 0.177,0.156 10 true *1 1.615,0.958 1.781,1.125 0.167,0.167 10 true *1 0.563,0.125 0.729,0.292 0.167,0.167 10 true *1 3.198,0.167 3.365,0.333 0.167,0.167 10 true *2 0.104,0.271 0.271,0.438 0.167,0.167 10 true *2

Tighten the intake manifold with the 3 bolts and 2 nuts.

Text in Illustration
*1 Bolt
*2 Nut

Torque:
21 N*m (214 kgf*cm, 15 ft.*lbf)


f.

Connect the fuel vapor feed hose and ventilation hose.


g.
A267685

Connect the 4 wire harness clamps and water by-pass hose.


Hide 17138B 2.INSTALL INTAKE MANIFOLD STAY

a.

Tighten the intake manifold stay with the 2 bolts.

Torque:
10 N*m (102 kgf*cm, 7 ft.*lbf)


Hide 89421 3.INSTALL MANIFOLD ABSOLUTE PRESSURE SENSOR

Hide 22030 6.INSTALL THROTTLE BODY WITH MOTOR ASSEMBLY