Home › Engine / Hybrid System › 1NZ-FXE (ENGINE CONTROL) › HEATED OXYGEN SENSOR › from 2014.12
RM2170E _51 Engine / Hybrid System _057003 1NZ-FXE ENGINE CONTROL _0277921 HEATED OXYGEN SENSOR A

1NZ-FXE ENGINE CONTROL  HEATED OXYGEN SENSOR  INSTALLATION  


PROCEDURE

Hide 89465 1.INSTALL HEATED OXYGEN SENSOR

a.
A267865E02
2.219,1.896 2.885,2.198 2.885,2.198 2.094,2.521 true 1.646,3.042 1.813,3.219 0.167,0.177 10 false *a 0.677,1.656 0.844,1.833 0.167,0.177 10 false *b 2.917,2.115 3.208,2.438 0.292,0.323 10 false SST

Using SST, install the heated oxygen sensor onto the front exhaust pipe.

Text in Illustration
*a Fulcrum Length
30 mm (1.18 in.)
*b Fulcrum Length
260 mm (10.2 in.)

SST
09224-00010  

Torque:
without SST : 44 N*m (449 kgf*cm, 32 ft.*lbf)
with SST : 39 N*m (398 kgf*cm, 29 ft.*lbf)

NOTICE:
·

The "with SST" torque value is effective when using SST with a fulcrum length of 30 mm (1.18 in.) and a torque wrench with a fulcrum length of 260 mm (10.2 in.) (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).

·

The "with SST" torque value is effective when SST is parallel to the torque wrench.