Home › Engine / Hybrid System › HYBRID / BATTERY CONTROL › HYBRID CONTROL SYSTEM › 2011.12–2014.12
RM2170E _51 Engine / Hybrid System _057004 HYBRID / BATTERY CONTROL _0277924 HYBRID CONTROL SYSTEM C

HYBRID / BATTERY CONTROL  HYBRID CONTROL SYSTEM  U0100-530  Lost Communication with ECM / PCM "A"  U0129-527  Lost Communication with Brake System Control Module  U0129-528  Lost Communication with Brake System Control Module  U0151-763  Communication Error from Airbag ECU to HV ECU  U0164-827  Communication Error from A/C ECU to HV ECU  U1107-436  Lost Communication with Power Management Module  


DESCRIPTION

The power management control ECU transmits and receives signals via CAN communication to and from the ECM, skid control ECU assembly, airbag sensor assembly, and air conditioning amplifier assembly.


DTC No. INF Code DTC Detection Condition Trouble Area
U0100 530 Problem with CAN communication between the ECM and power management control ECU (CAN communication system malfunction) CAN communication system
U0129 527 Problem with CAN communication (V BUS) between the skid control ECU assembly and power management control ECU (CAN communication system malfunction)
528 Problem with CAN communication between the skid control ECU assembly and power management control ECU (CAN communication system malfunction)
U0151 763 Problem with CAN communication between airbag sensor assembly and power management control ECU (CAN communication system malfunction)
U0164 827 Problem with CAN communication between air conditioning amplifier assembly and power management control ECU (CAN communication system malfunction)
U1107 436 Problem with CAN communication between the power source ECU and power management control ECU (CAN communication system malfunction)

CAUTION / NOTICE / HINT

HINT:

After the repair, clear the DTCs and perform the following procedure to check that DTCs are not output.

1.

Turn the power switch on (IG) and wait for 2 minutes or more.



PROCEDURE

1.CHECK DTC OUTPUT (ALL CODES)
a.

Connect the intelligent tester to the DLC3.


b.

Turn the power switch on (IG).


c.

Enter the following menus: System select / Utility / All Codes.


d.

Check if DTCs are output.

Result:
Result Proceed to
Power management control ECU outputs P2532-772 A
Power management control ECU does not output P2532-772 B



e.

Turn the power switch off.



A

B