The power management control ECU monitors the insulation monitoring circuit located in the battery smart unit and detects a malfunction.
| DTC No. | INF Code | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| P0AA7 | 727 | Malfunction in the insulation monitoring circuit in the battery smart unit | Battery smart unit |
After the repair, clear the DTCs and perform the following procedure to check that DTCs are not output.
Turn the power switch on (IG) and wait for 70 seconds or more.
NEXT
Connect the intelligent tester to the DLC3.
Turn the power switch on (IG) and wait for 1 minute or more.
Do not turn the power switch off until step 3 is complete.
Enter the following menus: Powertrain / Hybrid Control / Trouble Codes.
Check if DTCs are output.
| Result | Proceed to |
|---|---|
| P0AA7-727 is not output | A |
| P0AA7-727 is output | B |
A
B
Do not turn the power switch off while performing this inspection.
With the vehicle and engine stopped, turn the power switch on (READY) with park (P) selected and wait for 1 second or more. (If the engine starts, wait until the engine stops.)
While depressing the brake pedal without depressing the accelerator pedal, move the shift lever to D and wait for 1 minute. (Step A)
Drive the vehicle 50 cm (1.6 ft.) forward and perform step A.
Drive the vehicle another 50 cm (1.6 ft.) forward and perform step A. Repeat this procedure 5 times (minimum total driving distance: 2 m (6.6 ft.)).
Enter the following menus: Powertrain / Hybrid Control / Trouble Codes.
Check if DTCs are output.
| Result | Proceed to |
|---|---|
| P0AA6 is not output | A |
| P0AA6 is output | B |
A
B