Home › Engine / Hybrid System › HYBRID / BATTERY CONTROL › SERVICE PLUG GRIP › 2015.11–2017.06
RM2170E _51 Engine / Hybrid System _057004 HYBRID / BATTERY CONTROL _0277936 SERVICE PLUG GRIP A

HYBRID / BATTERY CONTROL  SERVICE PLUG GRIP  INSTALLATION  


PROCEDURE

Hide G3834 1.INSTALL SERVICE PLUG GRIP

CAUTION:

Wear insulating gloves.


NOTICE:

Before connecting the service plug, check that no parts and tools remain and that the high voltage terminals and connectors are connected securely.


a.

Wear insulated gloves and install the service plug grip in the order shown in the illustration.

A266731


b.

Rotate the handle of the service plug grip 90° toward the battery and slide it in the direction shown by the arrow until a click sound is heard.


Hide 58167H 2.INSTALL FRONT CENTER FLOOR COVER (for Separate Type Seatback)

Hide 58167H 3.INSTALL FRONT CENTER FLOOR COVER (for Bench Type Seatback)

Hide 58166B 4.INSTALL FRONT FLOOR COVER LH (for Separate Type Seatback)

Hide 58166B 5.INSTALL FRONT FLOOR COVER LH (for Bench Type Seatback)

Hide 6.CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 58165F 7.INSTALL FRONT FLOOR COVER RH (for Separate Type Seatback)

Hide 58165F 8.INSTALL FRONT FLOOR COVER RH (for Bench Type Seatback)