If the message "MAINTENANCE REQUIRED FOR HYBRID BATTERY COOLING PARTS AT YOUR DEALER" is displayed on the multi-information display, inspect the battery cooling blower assembly (See page Engine / Hybrid System>HYBRID / BATTERY CONTROL>BATTERY BLOWER>INSPECTION).
58165F
1.REMOVE FRONT FLOOR COVER RH (for Separate Type Seatback)
58165F
2.REMOVE FRONT FLOOR COVER RH (for Bench Type Seatback)
58166B
3.REMOVE FRONT FLOOR COVER LH (for Separate Type Seatback)
58166B
4.REMOVE FRONT FLOOR COVER LH (for Bench Type Seatback)
58167H
5.REMOVE FRONT CENTER FLOOR COVER (for Separate Type Seatback)
58167H
6.REMOVE FRONT CENTER FLOOR COVER (for Bench Type Seatback)
7.REMOVE REAR SEAT CUSHION ASSEMBLY (for Separate Type Seatback)
8.REMOVE REAR SEAT CUSHION ASSEMBLY (for Bench Type Seatback)
G9230
9.REMOVE BATTERY COOLING BLOWER ASSEMBLY
Be sure not to touch the fan part of the battery cooling blower assembly.
Do not lift the battery cooling blower assembly using the wire harness.
Do not disassemble the battery cooling blower assembly.
Disconnect the battery cooling blower assembly connector and disengage the clamp.
Remove the nut, 2 bolts and battery cooling blower assembly.