For the assembly procedure of the inverter with converter assembly, refer to the assembly procedure of the MG control computer with bracket sub-assembly (See page Engine / Hybrid System>HYBRID / BATTERY CONTROL>MOTOR GENERATOR CONTROL COMPUTER>REASSEMBLY).
1.INSTALL INVERTER CURRENT SENSOR SUB-ASSEMBLY
Insert the bus-bars of the inverter terminal sub-assembly into the inverter current sensor sub-assembly as shown in the illustration.
| *1 | Bus-bar |
| *2 | Inverter current sensor sub-assembly |
Install the inverter current sensor sub-assembly with the 2 bolts.
| *a | Terminal Tray |
Engage the wire harness of inverter current sensor sub-assembly to the 2 clamps as shown in the illustration.
Remove the protective tape.
| *1 | Protective Tape | - | - |
| *a | Terminal Tray | - | - |