Home › Engine / Hybrid System › 1NZ-FXE (ENGINE MECHANICAL) › REAR CRANKSHAFT OIL SEAL
RM2170E _51 Engine / Hybrid System _057005 1NZ-FXE ENGINE MECHANICAL _0277947 REAR CRANKSHAFT OIL SEAL A

1NZ-FXE ENGINE MECHANICAL  REAR CRANKSHAFT OIL SEAL  REMOVAL  


PROCEDURE

Hide 30900 1.REMOVE HYBRID VEHICLE TRANSAXLE ASSEMBLY

(See page Drivetrain>P510 (HYBRID TRANSMISSION / TRANSAXLE)>HYBRID VEHICLE TRANSAXLE>REMOVAL)

NOTICE:

Be careful not to apply excess force to the transmission input damper assembly when removing or installing the hybrid vehicle transaxle assembly. If excess force is applied, the transmission input damper assembly may be damaged, or its splines may become misaligned.


Hide 31270 2.REMOVE TRANSMISSION INPUT DAMPER ASSEMBLY

a.
A266942E01
0.214,0.993 0.511,1.146 0.297,0.153 10 SST 1.258,1.078 0.566,1.078 false 0.201,1.711 0.498,1.865 0.297,0.153 10 SST 1.203,1.796 0.553,1.796 false

Using SST, hold the crankshaft damper sub-assembly.

SST
09213-58012  (91111-50845)
09330-00021  


b.
A266943

Remove the 6 bolts and transmission input damper assembly from the flywheel sub-assembly.


Hide 13405 3.REMOVE FLYWHEEL SUB-ASSEMBLY

a.
A266942E01
0.214,0.993 0.511,1.146 0.297,0.153 10 SST 1.258,1.078 0.566,1.078 false 0.201,1.711 0.498,1.865 0.297,0.153 10 SST 1.203,1.796 0.553,1.796 false

Using SST, hold the crankshaft damper sub-assembly.

SST
09213-58012  (91111-50845)
09330-00021  


b.
A266944

Remove the 6 bolts and flywheel sub-assembly.


Hide 11401L 4.REMOVE REAR ENGINE OIL SEAL

a.
A154925E14
0.823,1.385 0.885,1.823 0.885,1.823 0.948,1.823 false 2.073,1.344 2.844,0.917 2.844,0.917 2.979,0.917 false 0.99,1.74 1.177,1.927 0.188,0.188 10 false *a 3.021,0.844 3.208,1.031 0.188,0.188 10 false *1

Using a knife, cut off the lip of the rear engine oil seal.

Text in Illustration
*1 Protective Tape
*a Cut Position


b.

Using a screwdriver with its tip wrapped with tape, pry out the rear engine oil seal.

NOTICE:

Do not damage the surface of the oil seal press fit hole or the crankshaft.


HINT:
·

Wrap the screwdriver tip with protective tape before use.

·

After removing, check the crankshaft for damage. If damaged, smooth the surface with 400-grit sandpaper.