Home › Engine / Hybrid System › 1NZ-FXE FUEL › FUEL PUMP › 2011.12–2017.06
RM2170E _51 Engine / Hybrid System _057006 1NZ-FXE FUEL _0277955 FUEL PUMP A

1NZ-FXE FUEL  FUEL PUMP  REASSEMBLY  


PROCEDURE

Hide 23220A 1.INSTALL FUEL PUMP WITH FILTER ASSEMBLY

a.
A192863E09
2.49,0.385 2.063,0.604 false 2.052,0.792 2.479,0.865 false 2.552,0.302 2.729,0.604 0.177,0.302 10 false *1 2.542,0.802 2.719,1.104 0.177,0.302 10 false *2

Apply gasoline to a new O-ring. Then install the O-ring and spacer to the fuel pump with filter assembly.

Text in Illustration
*1 O-ring
*2 Fuel Pump Spacer


b.

Connect the fuel pump harness connector.


c.

Engage the 5 claws of the fuel pump with filter assembly.

NOTICE:
·

Make sure that the O-ring is not cut or pinched during installation.

·

Engage the claws securely.

·

Do not remove the suction filter.



HINT:

Perform "Inspection After Repair" after replacing the fuel pump assembly (See page Engine / Hybrid System>1NZ-FXE (ENGINE CONTROL)>SFI SYSTEM (w/o Canister Pump Module)>INITIALIZATION).



d.

Engage the 2 claws to install the No. 1 fuel suction support.


e.

Engage the 2 claws of the No. 1 fuel suction support and install the fuel filter and the fuel pump with filter assembly onto the No. 1 fuel sub-tank.


f.
A265015

Align the groove of the suction filter hose with the cutout of the No. 1 fuel sub-tank and install the hose.

NOTICE:

Do not apply excessive force to the fuel tube or the fuel suction plate.



g.
A406619C02
0.375,1.5 0.75,1.5 false 1.479,1.542 1.75,1.323 1.75,1.323 1.958,1.323 true 0.208,1.417 0.521,1.573 0.313,0.156 10 false *a 2,1.25 2.208,1.406 0.208,0.156 10 true *b
*a Fuel Tube
*b Wire Harness


Connect the fuel pump harness connector as shown in the illustration.

NOTICE:

Make sure that the wire harness is arranged as shown in the illustration.