77216A
1.INSTALL NO. 1 FUEL TANK FILLER PIPE SUPPORT
Install the No. 1 fuel tank filler pipe support in the position shown in the illustration.
77217C
2.INSTALL NO. 2 FUEL TANK FILLER PIPE SUPPORT
Install the No. 2 fuel tank filler pipe support in the position shown in the illustration.
| *a | Clamp Position |
77281G
3.INSTALL FUEL HOSE CLAMP
Install the fuel hose clamp onto the fuel tank assembly.
77701W
4.REMOVE NO. 1 CANISTER OUTLET HOSE SUB-ASSEMBLY
Install the No. 1 canister outlet hose sub-assembly to the fuel tank assembly.
77209F
5.INSTALL FUEL TANK MAIN TUBE SUB-ASSEMBLY
Install the fuel tank main tube onto the fuel tank assembly.
77100
6.INSTALL FUEL TANK ASSEMBLY
Clean and degrease the bolt holes.
Using an engine lifter, set the fuel tank assembly in the installation position.
Do not drop the fuel tank.
Install the fuel tank assembly with 4 new bolts.
Install the 2 fuel hoses to the position shown in the illustration.
Install the fuel tank filler pipe flange plate as shown in the illustration.
| *1 | Fuel Tank Filler Pipe Flange Plate |
| *2 | Air Tube |
Install the bolt.
Install the air tube as shown in the illustration.
77209F
7.CONNECT FUEL TANK MAIN TUBE SUB-ASSEMBLY
Align the fuel tube connector with the fuel pipe, connect the fuel tube connector and push the retainer in until the retainer makes a "click" sound to lock the claws of the retainer.
| *1 | Fuel Tank Main Tube Sub-assembly |
| *2 | Fuel Tank Pipe Setting Holder |
| *3 | Retainer |
| *4 | Nylon Tube |
| *5 | O-ring |
| *6 | Fuel Tube Connector |
| *7 | Fuel Pipe |
Check that there is no damage or foreign matter around the connecting parts of the fuel tube connector and fuel pipe before starting this step.
After connecting the fuel tube connector, check that the fuel tube connector is securely connected by pulling on the fuel tube connector.
Engage the 3 clamps and install the fuel tank pipe setting holder.
77266A
8.INSTALL NO. 1 FUEL TUBE PROTECTOR
Install the No. 1 fuel tube protector to the fuel tube connector.
77262
9.CONNECT NO. 2 FUEL EMISSION TUBE
Connect the No. 2 fuel emission tube, then fit it with the clip as shown in the illustration.
| *a | Up |
| *b | 120° |
Check that there is no damage or foreign matter around the connecting parts of the No. 2 fuel emission tube and fuel pipe before performing this work.
77606
10.INSTALL NO. 1 FUEL TANK PROTECTOR SUB-ASSEMBLY
Install the No. 1 fuel tank protector sub-assembly with the bolt and clip.
58156
11.INSTALL FRONT NO. 4 FLOOR HEAT INSULATOR
Install the front No. 4 floor heat insulator with the 2 nuts.
| *a | Front |
77310A
12.INSTALL FUEL TANK CAP ASSEMBLY
77020A
13.INSTALL FUEL SUCTION TUBE WITH PUMP AND GAUGE ASSEMBLY
14.ADD FUEL