Home › Engine / Hybrid System › 1NZ-FXE (COOLING) › THERMOSTAT
RM2170E _51 Engine / Hybrid System _057009 1NZ-FXE COOLING _0277975 THERMOSTAT G

1NZ-FXE COOLING  THERMOSTAT  INSPECTION  


PROCEDURE

Hide 16031 1.INSPECT WATER INLET WITH THERMOSTAT SUB-ASSEMBLY

A268771

HINT:

The valve opening temperature is inscribed on the water inlet with thermostat sub-assembly.


a.

Immerse the water inlet with thermostat sub-assembly in water and then gradually heat the water.


b.

Check the valve opening temperature of the water inlet with thermostat sub-assembly.

Valve opening temperature:

80 to 84°C (176 to 183°F)


HINT:

If the valve opening temperature is not as specified, replace the water inlet with thermostat sub-assembly (See page Engine / Hybrid System>1NZ-FXE (COOLING)>THERMOSTAT>REMOVAL).



c.
A268770E01
0.87,0 1.049,0.171 0.179,0.171 10 *a

Check the valve lift.

Text in Illustration
*a Valve Lift

Valve lift:

8.0 mm (0.315 in.) or more at 95°C (203°F)


HINT:

If the valve lift is not as specified, replace the water inlet with thermostat sub-assembly (See page Engine / Hybrid System>1NZ-FXE (COOLING)>THERMOSTAT>REMOVAL).



d.

Check that the valve is fully closed when the water inlet with thermostat sub-assembly is at low temperatures (below 77°C (171°F)).

HINT:

If it is not fully closed, replace the water inlet with thermostat sub-assembly (See page Engine / Hybrid System>1NZ-FXE (COOLING)>THERMOSTAT>REMOVAL).