1.CHECK ENGINE OIL LEVEL
Put the engine in inspection mode (See page General>INTRODUCTION>REPAIR INSTRUCTION>INSPECTION MODE PROCEDURE).
Warm up and stop the engine, then wait for 5 minutes. The oil level should be between the low and full level marks on the engine oil level dipstick. If the engine oil level is low, check for leaks and add oil up to the full level mark.
Do not fill with engine oil to above the full level mark.
2.CHECK ENGINE OIL
Check the engine oil for deterioration, water contamination, discoloring or thinning. If the condition is visibly poor, replace the engine oil and oil filter element.
3.INSPECT OIL PRESSURE
Remove the oil pressure switch (See page Engine / Hybrid System>1NZ-FXE (LUBRICATION)>OIL PRESSURE SWITCH>REMOVAL).
Install an oil pressure gauge with the adapter.
Put the engine in inspection mode (See page General>INTRODUCTION>REPAIR INSTRUCTION>INSPECTION MODE PROCEDURE).
Warm up the engine.
Check the oil pressure.
| Engine Condition | Oil Pressure |
|---|---|
| Idle | 59 kPa (0.6 kgf/cm2, 8.6 psi) or more |
| 2500 rpm | 140 to 280 kPa (1.4 to 2.9 kgf/cm2, 20 to 41 psi) |
If the oil pressure is not as specified, check the oil pump (See page Engine / Hybrid System>1NZ-FXE (LUBRICATION)>OIL PUMP>INSPECTION).
Remove the oil pressure gauge with the adapter.
Install the oil pressure switch (See page Engine / Hybrid System>1NZ-FXE (LUBRICATION)>OIL PRESSURE SWITCH>INSTALLATION).
Inspect for oil leak.