Home › Engine / Hybrid System › CRUISE CONTROL › CRUISE CONTROL SYSTEM › 2011.12–2014.12
RM2170E _51 Engine / Hybrid System _057012 CRUISE CONTROL _0277986 CRUISE CONTROL SYSTEM J

CRUISE CONTROL  CRUISE CONTROL SYSTEM  Cruise Main Indicator Light Circuit  


DESCRIPTION

·

The power management control ECU turns on the cruise control indicator light by sending indicator output demand signals to the combination meter assembly using CAN communication.

·

The cruise control indicator light illuminates when the cruise control system has been turned on using the ON-OFF switch. If a malfunction is detected, the cruise control indicator light off.

·

The cruise control indicator light circuit uses CAN communication. If the cruise control indicator light is not functioning correctly, check for CAN communication DTCs before troubleshooting this circuit.


WIRING DIAGRAM

E230248E13
0.845,2.258 2.638,2.428 1.793,0.170 10 : CAN Communication Line 1.015,1.907 2.881,2.086 1.866,0.179 10 Combination Meter Assembly 1.015,1.731 1.316,1.898 0.301,0.167 10 G1 4.835,1.731 5.131,1.898 0.296,0.167 10 G58 4.923,0.691 5.357,0.865 0.434,0.174 10 CA1H 4.937,1.183 5.371,1.344 0.434,0.161 10 CA1L 2.106,0.677 2.540,0.907 0.434,0.230 10 CANH 2.106,1.183 2.540,1.413 0.434,0.230 10 CANL 2.609,0.491 2.820,0.647 0.211,0.156 10 31 4.668,0.505 4.880,0.661 0.211,0.156 10 25 4.668,1.019 4.880,1.175 0.211,0.156 10 24 2.609,1.014 2.820,1.170 0.211,0.156 10 32 4.835,1.907 6.941,2.104 2.106,0.197 10 Power Management Control ECU

PROCEDURE

1.PERFORM ACTIVE TEST USING INTELLIGENT TESTER
a.

Connect the intelligent tester to the DLC3.


b.

Turn the power switch on (IG).


c.

Turn the intelligent tester on.


d.

Select the following menu items: Body / Combination Meter / Active Test.


e.

Check the cruise control indicator light by performing the Active Test.

Combination Meter
Tester Display Test Part Control Range Diagnostic Note
Indicat. Lamp Cruise Cruise control indicator light Cruise control indicator light ON / OFF -

OK:

The cruise control indicator light goes on or off.




OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

NG

REPLACE COMBINATION METER ASSEMBLY