Home › Vehicle Interior › METER / GAUGE / DISPLAY › COMBINATION METER › 2011.12–2014.12
RM2170E _58 Vehicle Interior _057037 METER / GAUGE / DISPLAY _0278097 COMBINATION METER A

METER / GAUGE / DISPLAY  COMBINATION METER  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the power switch off, waiting time may be required before disconnecting the cable from the auxiliary battery negative (-) terminal. Therefore, make sure to read the disconnecting the cable from the auxiliary battery negative (-) terminal notices before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 3.DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 55405B 4.REMOVE CENTER INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY

Hide 55660 5.REMOVE NO. 2 INSTRUMENT PANEL REGISTER ASSEMBLY (for LHD)

Hide 55650 6.REMOVE NO. 1 INSTRUMENT PANEL REGISTER ASSEMBLY (for RHD)

Hide 55474B 7.REMOVE INSTRUMENT CLUSTER FINISH PANEL GARNISH

Hide 55670A 8.REMOVE CENTER INSTRUMENT PANEL REGISTER ASSEMBLY

Hide 55404D 9.REMOVE INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY

Hide 83100 10.REMOVE COMBINATION METER ASSEMBLY

a.
E244444

Remove the 2 screws.


b.
E244445

Disengage the 3 clips as shown in the illustration.


c.
E244446

Disconnect the 2 connectors.


d.

Disengage the clamp and remove the combination meter assembly.