When the brake pedal is depressed, the stop light switch assembly sends a signal to the hybrid vehicle control ECU. When the hybrid vehicle control ECU receives this signal, it cancels the cruise control. The fail-safe function operates to enable normal driving even if there is a malfunction in the stop light signal circuit. Cruise control cancellation occurs when voltage is applied to terminal STP. When the brake is applied, voltage is normally applied to terminal STP of the hybrid vehicle control ECU through the STOP fuse and the stop light switch assembly, and the hybrid vehicle control ECU turns the cruise control off.
| DTC No. | DTC Detection Condition | Trouble Area |
|---|---|---|
| P0571 | Voltage of STP signal and that of ST1- signal of hybrid vehicle control ECU are less than 1 V for 0.5 seconds or more | ·
Stop light switch assembly ·
Stop light switch circuit ·
Hybrid vehicle control ECU |
Inspect the fuses for circuits related to this system before performing the following inspection procedure.
Disconnect the A65 stop light switch assembly connector.
Measure the voltage and resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| A65-1 (B)- A65-3 (GND) | Power switch off | 11 to 14 V |
| A65-5 (B)- A65-3 (GND) | Power switch on (IG) | 11 to 14 V |
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| A65-3 (GND) - Body ground | Always | Below 1 Ω |
| *a | Front view of wire harness connector
(to Stop Light Switch Assembly) |
OK
NG
Inspect the stop light switch assembly (See page Vehicle Exterior>LIGHTING (EXT)>STOP LIGHT SWITCH>ON-VEHICLE INSPECTION).
OK
NG
Disconnect the A71 and A72 hybrid vehicle control ECU connectors.
Disconnect the A65 stop light switch assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| A71-15 (STP) - A65-2 (OUT) | Always | Below 1 Ω |
| A72-28 (ST1-) - A65-4 (L) | Always | Below 1 Ω |
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| A71-15 (STP) or A65-2 (OUT) - Body ground | Always | 10 kΩ or higher |
| A72-28 (ST1-) or A65-4 (L) - Body ground | Always | 10 kΩ or higher |
OK
NG