Home › Drivetrain › P510 (HYBRID TRANSMISSION / TRANSAXLE) › INPUT SHAFT OIL SEAL
RM2170E _52 Drivetrain _057013 P510 HYBRID TRANSMISSION / TRANSAXLE _0277992 INPUT SHAFT OIL SEAL A

P510 HYBRID TRANSMISSION / TRANSAXLE  INPUT SHAFT OIL SEAL  REPLACEMENT  


PROCEDURE

Hide 30900 1.REMOVE HYBRID VEHICLE TRANSAXLE ASSEMBLY

Hide 35710A 2.REMOVE INPUT SHAFT TYPE T OIL SEAL

a.
C249664E01
0.674,0.298 0.840,0.457 0.166,0.159 10 *1 1.581,1.209 0.976,0.382 0.976,0.382 0.876,0.382 false

Using a screwdriver with its tip taped, remove the input shaft type T oil seal.

Text in Illustration
*1 Vinyl Tape

NOTICE:

When removing the input shaft type T oil seal, make sure not to damage the input shaft or hybrid vehicle transaxle housing.



Hide 35710A 3.INSTALL INPUT SHAFT TYPE T OIL SEAL

a.
C249665E01
2.399,2.861 2.705,3.021 0.307,0.160 10 SST 1.937,2.005 2.272,2.946 2.272,2.946 2.367,2.946 false

Coat the lip of a new input shaft type T oil seal with MP grease.


b.

Using SST and a hammer, tap in the input shaft type T oil seal.

SST
09330-50010  

Oil seal installation depth:

1.0 to 1.8 mm (0.0394 to 0.0709 in.)


NOTICE:
·

Ensure that no foreign matter adheres to the input shaft type T oil seal lip.

·

Ensure that the input shaft type T oil seal is not at an angle.




Hide 30900 4.INSTALL HYBRID VEHICLE TRANSAXLE ASSEMBLY