Home › Drivetrain › DRIVE SHAFT / PROPELLER SHAFT › FRONT DRIVE SHAFT ASSEMBLY › 2013.12–2014.12
RM2170E _52 Drivetrain _057014 DRIVE SHAFT / PROPELLER SHAFT _0277996 FRONT DRIVE SHAFT ASSEMBLY A

DRIVE SHAFT / PROPELLER SHAFT  FRONT DRIVE SHAFT ASSEMBLY  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH side and LH side.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 43420G 1.INSTALL FRONT DRIVE SHAFT HOLE SNAP RING

a.

Install a new front drive shaft hole snap ring to the front drive inboard joint assembly.

NOTICE:

Face the end gap of the front drive inboard joint hole snap ring downward.



Hide 43420 2.INSTALL FRONT DRIVE SHAFT ASSEMBLY

a.

Coat the lip of the hybrid vehicle transaxle assembly type T oil seal with MP grease.


b.

Coat the lip of the transaxle case oil seal with MP grease.


c.
C107969

Align the inboard joint splines, and using a brass bar and a hammer, install the front drive shaft assembly.

NOTICE:
·

Face the end gap of the front drive shaft hole snap ring downward.

·

Do not damage the hybrid vehicle transaxle assembly type T oil seal.

·

Do not damage the inboard joint boot.

·

Make sure to center the front drive shaft assembly during installation to prevent damage to the front drive shaft hole snap ring.



HINT:

Confirm whether the drive shaft is securely driven in by checking the reaction force and sound.



d.

Align the matchmarks and install the front drive shaft assembly to the front axle hub sub-assembly.

NOTICE:

Be careful not to damage the front axle outboard joint boot.



Hide 48069 3.CONNECT FRONT LOWER NO. 1 SUSPENSION ARM SUB-ASSEMBLY

Hide 48810 4.INSTALL FRONT STABILIZER LINK ASSEMBLY

Hide 45047 5.INSTALL TIE ROD END SUB-ASSEMBLY

Hide 43502H 7.INSTALL FRONT AXLE SHAFT NUT

a.

Clean the threaded parts on the front drive shaft assembly and a new front axle shaft nut using a non-residue solvent.

HINT:
·

Be sure to perform this work even when using a new drive shaft.

·

Keep the threaded parts free of oil and foreign matter.




b.
C235879

Using a socket wrench (30 mm), install the axle shaft nut.

Torque:
216 N*m (2203 kgf*cm, 159 ft.*lbf)


c.

Using a chisel and hammer, stake the front axle shaft nut.


Hide 10.INSTALL FRONT WHEELS

Torque:
103 N*m (1050 kgf*cm, 76 ft.*lbf)

Hide 11.INSPECT AND ADJUST FRONT WHEEL ALIGNMENT

Hide 51442C 12.INSTALL ENGINE UNDER COVER LH

Hide 51441C 13.INSTALL ENGINE UNDER COVER RH