The front lower No. 1 suspension arm sub-assembly LH can be removed directly from the vehicle.
1.REMOVE FRONT WHEEL
48069
2.SEPARATE FRONT LOWER NO. 1 SUSPENSION ARM SUB-ASSEMBLY LH
Remove the clip and nut.
Install SST to the threaded section of the lower ball joint.
Make sure that the upper ends of the threaded section of the lower ball joint and SST are aligned.
Using SST, separate the front lower No. 1 suspension arm sub-assembly LH from the steering knuckle.
| *a | Apply grease | *b | Place wrench here |
Apply grease to the threads and end of the SST bolt.
Make sure to tie the string of SST to the vehicle to prevent SST from dropping.
Install SST so that A and B are parallel.
Be sure to place the wrench on the part indicated in the illustration.
Do not damage the lower ball joint dust cover.
Do not damage the drive shaft outboard joint boots.
Do not damage the front disc brake dust cover.
Do not damage the steering knuckle.
48069
3.REMOVE FRONT LOWER NO. 1 SUSPENSION ARM SUB-ASSEMBLY LH
Remove the 2 bolts and front lower No. 1 suspension arm sub-assembly LH from the front suspension crossmember sub-assembly.
48068
4.REMOVE FRONT LOWER NO. 1 SUSPENSION ARM SUB-ASSEMBLY RH