1.PLACE FRONT WHEELS FACING STRAIGHT AHEAD
2. SECURE STEERING WHEEL
45259A
3.REMOVE COLUMN HOLE COVER SILENCER SHEET
45209
4.SEPARATE STEERING SLIDING YOKE SUB-ASSEMBLY
45025D
5.SEPARATE NO. 1 STEERING COLUMN HOLE COVER SUB-ASSEMBLY
6.REMOVE FRONT WHEEL
48810
7.SEPARATE FRONT STABILIZER LINK ASSEMBLY LH
Remove the nut and separate the front stabilizer link assembly LH from the front stabilizer bar.
Use a hexagon socket wrench to hold the stud.
48820B
8.SEPARATE FRONT STABILIZER LINK ASSEMBLY RH
Perform the same procedure as the LH side.
45047
9.SEPARATE TIE ROD END SUB-ASSEMBLY LH
45046
10.SEPARATE TIE ROD END SUB-ASSEMBLY RH
Perform the same procedure as the LH side.
48069
11.SEPARATE FRONT LOWER NO. 1 SUSPENSION ARM SUB-ASSEMBLY LH
48068
12.SEPARATE FRONT LOWER NO. 1 SUSPENSION ARM SUB-ASSEMBLY RH
Perform the same procedure as the LH side.
51201
13.REMOVE FRONT SUSPENSION CROSSMEMBER SUB-ASSEMBLY
Using a jack and a wooden block, support the engine and transaxle assembly.
| *1 | Jack |
| *2 | Wooden Block |
|
Front of the Vehicle |
Remove the bolt and separate the engine moving control rod.
Support the front suspension crossmember sub-assembly with an engine lifter using 4 attachments or equivalent tools as shown in the illustration.
| *1 | Engine Lifter |
| *2 | Attachment |
|
Front of the Vehicle |
|
Attachment Placement Location |
Make sure to secure the front suspension crossmember sub-assembly to prevent it from dropping.
Use the attachments to keep the front suspension crossmember sub-assembly level.
The front suspension crossmember sub-assembly is a heavy component. Make sure that it is supported securely.
Remove the 6 bolts and front suspension crossmember sub-assembly.
Slowly lower the front suspension crossmember sub-assembly.
When lowering the front suspension crossmember sub-assembly, be careful not to damage the vehicle body or other components installed on the vehicle.
14.REMOVE STEERING LINK ASSEMBLY
48829A
15.REMOVE FRONT NO. 1 STABILIZER BRACKET LH
48824A
16.REMOVE FRONT NO. 1 STABILIZER BRACKET RH
Perform the same procedure as the LH side.
48811
17.REMOVE FRONT STABILIZER BAR
48069
18.REMOVE FRONT LOWER NO. 1 SUSPENSION ARM SUB-ASSEMBLY LH
Remove the bolt and front lower No. 1 suspension arm sub-assembly LH from the front suspension crossmember sub-assembly.
48068
19.REMOVE FRONT LOWER NO. 1 SUSPENSION ARM SUB-ASSEMBLY RH
Perform the same procedure as the LH side.
12363A
20.REMOVE ENGINE MOVING CONTROL ROD
Remove the bolt and engine moving control rod from the front suspension crossmember sub-assembly.