48815
1.INSTALL FRONT NO. 1 STABILIZER BAR BUSHING
Install the 2 front No. 1 stabilizer bar bushings to the front stabilizer bar.
| *1 | Stopper Ring |
|
Front of the Vehicle |
|
Outside of the Vehicle |
Install the front No. 1 stabilizer bar bushing onto the front stabilizer bar so that the stopper ring of the front stabilizer bar faces the outside of the vehicle.
Install the front No. 1 stabilizer bar bushing with its cutout facing the front of the vehicle.
48811
2.INSTALL FRONT STABILIZER BAR
Install the front stabilizer bar to the front suspension crossmember sub-assembly so that the identification mark is positioned on the left side of the vehicle.
| *a | Identification Mark |
|
Left Side of the Vehicle |
48829A
3.INSTALL FRONT NO. 1 STABILIZER BRACKET LH
Install the front No. 1 stabilizer bracket LH to the front suspension crossmember sub-assembly with the 2 bolts.
|
Front of the Vehicle |
Temporarily tighten the bolt A and then fully tighten the 2 bolts in the order of B and A.
48824A
4.INSTALL FRONT NO. 1 STABILIZER BRACKET RH
Perform the same procedure as the LH side.
5.INSTALL STEERING LINK ASSEMBLY
48810
6.INSTALL FRONT STABILIZER LINK ASSEMBLY LH
48820B
7.INSTALL FRONT STABILIZER LINK ASSEMBLY RH
Perform the same procedure as the LH side.
51201
8.INSTALL FRONT SUSPENSION CROSSMEMBER SUB-ASSEMBLY