Home › Suspension › TIRE / WHEEL › TIRE AND WHEEL SYSTEM › 2011.12–2015.11
RM2170E _53 Suspension _057020 TIRE / WHEEL _0278019 TIRE AND WHEEL SYSTEM G

TIRE / WHEEL  TIRE AND WHEEL SYSTEM  INSPECTION  


PROCEDURE

Hide 1.INSPECT TIRES

a.

Check the tires for wear and proper inflation pressure.

Cold Tire Inflation Pressure:
Tire Size Front
kPa (kgf/cm2, psi)
Rear
kPa (kgf/cm2, psi)
175/65R15 84H 230 (2.3, 33) 220 (2.2, 32)
195/50R16 84V 220 (2.2, 32) 200 (2.0, 29)
185/60R15 84H 220 (2.2, 32) 220 (2.2, 32)



b.
C164558

Using a dial indicator, check the runout of the tires.

Maximum tire runout:
Vertical:

1.4 mm (0.0551 in.)

Lateral:

2.0 mm (0.0787 in.)



Hide 2. ROTATE TIRES

a.
C143305E04
2.896,0.397 3.142,0.573 0.246,0.177 10 (A) 2.896,1.454 3.142,1.630 0.246,0.177 10 (B)

If the spare tire uses a different type of wheel than the other tires, rotate the tires as shown by (A) in the illustration. If the spare tire has the same type of wheel as the other tires, rotate the tires, including the spare tire, as shown by (B) in the illustration.

Text in Illustration
V100135

Front


Hide 3.INSPECT AND ADJUST WHEEL BALANCE

a.

Inspect and adjust the off-the-car balance.

i.

Steel wheel:

Maximum imbalance:

8.0 g (0.0176 lb)



ii.
C144018E06
2.044,3.649 2.258,3.817 0.214,0.168 10 (A)

Others (Non-steel wheel):

Maximum imbalance:

8.0 g (0.0176 lb)


NOTICE:
·

Use a cleaning detergent to remove dirt, oil and water from the surface where the balance weight is to be adhered.

·

Do not touch the adhesive surface of the tape.

·

Adhere a sticking type balance weight to the flat surface (A) shown in the illustration.

Width (A):

25 mm (0.984 in.)


·

Push the balance weight securely with your finger to adhere it to the desired position.

·

Do not reuse balance weights.



HINT:

The inner side balance weight should be installed by clipping it to the rim.




Hide 4.INSPECT FRONT AXLE HUB BEARING