When the brake pedal is first depressed after replacing the brake shoes or pushing back the wheel brake cylinder piston, DTC C1214 may be output. As there is no malfunction, clear the DTC.
While the auxiliary battery is connected, even if the power switch is off, the brake control system activates when the brake pedal is depressed or the door courtesy switch is turned on. Therefore, even if only brake shoes are to be removed and installed, be sure to perform the Disable Brake Control procedure and disconnect the cable from the negative (-) terminal of the auxiliary battery before beginning work.
Use the same procedure for the RH side and LH side.
The procedure listed below is for the LH side.
1. PRECAUTION
After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).
2. DISABLE BRAKE CONTROL
3.REMOVE REAR WHEEL
42403
4.REMOVE REAR BRAKE DRUM SUB-ASSEMBLY
5.INSPECT REAR AXLE HUB BEARING LOOSENESS
Using a dial indicator, check for looseness near the center of the rear axle hub.
0.05 mm (0.00196 in.)
Ensure that the dial indicator is set perpendicular to the measurement surface.
Keep the magnet of the dial indicator away from the rear axle hub and bearing assembly (rear speed sensor).
If the looseness exceeds the maximum, replace the rear axle hub and bearing assembly.
6.INSPECT REAR AXLE HUB RUNOUT
Using a dial indicator, check for runout on the surface of the axle hub outside the rear axle hub bolts.
0.07 mm (0.00276 in.)
Ensure that the dial indicator is set perpendicular to the measurement surface.
Make sure to set the tip of the dial indicator towards the outside of the rear axle hub bolts.
Keep the magnet of the dial indicator away from the rear axle hub and bearing assembly (rear speed sensor).
If the runout exceeds the maximum, replace the rear axle hub and bearing assembly.
42403
7.INSTALL REAR BRAKE DRUM SUB-ASSEMBLY
8.INSTALL REAR WHEEL
9.CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL
Connect the cable to the negative (-) auxiliary battery terminal (See page Power Source / Network>1NZ-FXE BATTERY / CHARGING>AUXILIARY BATTERY>INSTALLATION).
Connect the reservoir level switch connector.
Clear the DTCs (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ELECTRONICALLY CONTROLLED BRAKE SYSTEM>DTC CHECK / CLEAR).