Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › VSC OFF SWITCH › from 2014.12
RM2170E _54 Brake _057021 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0278026 VSC OFF SWITCH G

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  VSC OFF SWITCH  INSPECTION  


PROCEDURE

Hide 84988L 1.INSPECT VSC OFF SWITCH

a.
C239020E01
0.325,0.309 0.523,0.472 0.198,0.163 10 *a 1.898,2.028 2.474,2.87 false 1.527,2.028 0.952,2.87 false 2.431,2.883 2.559,3.046 0.128,0.163 10 E 0.849,2.883 0.978,3.046 0.128,0.163 10 +

Make sure that there is no looseness in the locking part and the connecting part of the connector.


b.

Disconnect the VSC OFF switch connector.


c.

Check both the connector case and the terminal for deformation and corrosion.

OK:

No deformation or corrosion.



d.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Switch Condition Specified Condition
6 (+) - 3 (E) Switch pushed Below 1 Ω
6 (+) - 3 (E) Switch not pushed 10 kΩ or higher


Text in Illustration
*a Component without harness connected
(VSC OFF Switch)

If the result is not as specified, replace the VSC OFF switch.