BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS
ELECTRONICALLY CONTROLLED BRAKE SYSTEM
- PRECAUTION2011.12–2014.122014.12–2015.11from 2015.11
- PARTS LOCATION2011.12–2013.122013.12–2014.12from 2014.12
- SYSTEM DIAGRAM2011.12–2013.122013.12–2014.12from 2014.12
- SYSTEM DESCRIPTION2011.12–2013.122013.12–2014.122014.12–2015.112015.11–2017.06from 2017.06
- HOW TO PROCEED WITH TROUBLESHOOTING2011.12–2013.122013.12–2014.122014.12–2015.11from 2015.11
- CHECK FOR INTERMITTENT PROBLEMS
- INITIALIZATION
- CALIBRATION
- TEST MODE PROCEDURE2011.12–2014.122014.12–2015.112015.11–2018.08from 2018.08
- PROBLEM SYMPTOMS TABLE2011.12–2013.122013.12–2014.122014.12–2015.112015.11–2018.08from 2018.08
- TERMINALS OF ECU2011.12–2013.122013.12–2014.12from 2014.12
- DIAGNOSIS SYSTEM2011.12–2014.122014.12–2015.112015.11–2018.08from 2018.08
- DTC CHECK / CLEAR2011.12–2013.122013.12–2014.122014.12–2018.08from 2018.08
- FREEZE FRAME DATA2011.12–2014.12from 2014.12
- FAIL-SAFE CHART
- DATA LIST / ACTIVE TEST2011.12–2013.122013.12–2014.122014.12–2017.06from 2017.06
- DIAGNOSTIC TROUBLE CODE CHART2011.12–2013.122013.12–2014.122014.12–2015.11from 2015.11
- VEHICLE CONTROL HISTORY from 2014.12
- 36, 432011.12–2013.122013.12–2014.122014.12–2015.11from 2015.11
- 42, 452011.12–2013.122013.12–2014.122014.12–2015.11from 2015.11
- C1202/68 An open is detected in the switch signal circuit for 2 seconds or more.2011.12–2013.122013.12–2014.122014.12–2015.11from 2015.11
- C1203/95 Either of the following is detected: 1. Identification information sent from other ECUs does not match with...2011.12–2014.12from 2014.12
- C1210/36, C1336/982011.12–2014.122014.12–2015.11from 2015.11
- C1211/25, C1212/26, C1225/31, C1226/32, C1227/33, C1228/34, C1352/21, C1353/23, C1356/22, C1357/242011.12–2013.122013.12–2014.122014.12–2015.11from 2015.11
- C1214/62 Decrease in hydraulic pressure control performance. (Pressure increase malfunction)2011.12–2013.122013.12–2014.122014.12–2015.11from 2015.11
- C1231/31 While steering angle sensor communication is enabled, a malfunction signal output is received during the...2011.12–2013.122013.12–2014.122014.12–2015.11from 2015.11
- C1234/34, C1243/43, C1244/44, C1245/45, C1279/79, C1381/972011.12–2013.122013.12–2014.122014.12–2015.11from 2015.11
- C1235/35, C1236/36, C1238/38, C1239/39, C1275/75, C1276/76, C1277/77, C1278/782011.12–2013.122013.12–2014.122014.12–2015.11from 2015.11
- C1241/41, C1242/422011.12–2013.122013.12–2014.122014.12–2015.11from 2015.11
- C1246/46, C1281/81, C1364/612011.12–2013.122013.12–2014.122014.12–2015.11from 2015.11
- C1247/47, C1346/71, C1392/48
- C1249/49 When IG1 terminal voltage is 9.5 V or more, an open stop light switch circuit continues for 10 seconds or...2011.12–2013.122013.12–2014.122014.12–2015.112015.11–2017.06from 2017.06
- C1252/52, C1253/532011.12–2013.122013.12–2014.122014.12–2015.11from 2015.11
- C1256/56 Significant drop in accumulator pressure continues. (DTCs will be stored and the buzzer will operate when...2011.12–2013.122013.12–2014.122014.12–2015.11from 2015.11
- C1257/57 While accumulator pressure falls below hard pump ON pressure, the hard drive circuit does not operate for 1...
- C1259/58, C1310/512011.12–2014.12from 2014.12
- C1271/71, C1272/72, C1464/31, C1465/322011.12–2013.122013.12–2014.122014.12–2015.11from 2015.11
- C1273/73, C1274/74, C1466/33, C1467/342011.12–2013.122013.12–2014.122014.12–2015.11from 2015.11
- C1290/66 The steering angle sensor zero point is judged as an abnormal value.2011.12–2013.122013.12–2014.122014.12–2015.11from 2015.11
- C1300 Skid control ECU internal malfunction.2011.12–2014.122014.12–2015.11from 2015.11
- C1311/11, C1312/122011.12–2013.122013.12–2014.122014.12–2015.11from 2015.11
- C1345/66, C1368/672011.12–2013.122013.12–2014.12from 2014.12
- C1365/54 Sensor supply voltage (VACC) is 4.54 V or less, or 5.46 V or more for 0.8 seconds or more.2011.12–2013.122013.12–2014.122014.12–2015.11from 2015.11
- C1380/64 When the voltage at the IG1 terminal is 9.5 V or more and the stop light control relay drive output (STP0) is... 2011.12–2013.12
- C1391/69 Either of the following is detected: 1. Accumulator pressure sensor input does not increase before braking or...2011.12–2013.122013.12–2014.12from 2014.12
- C1439/66, C1445/662011.12–2013.122013.12–2014.122014.12–2015.11from 2015.11
- C1440/98 Driving at a steep bank angle.2011.12–2013.122013.12–2014.12from 2014.12
- C1442/44, C1443/342011.12–2014.122014.12–2015.11from 2015.11
- C1451/72 Air bleeding has not been performed.
- U0073/94, U0123/62, U0124/95, U0126/63, U0293/592011.12–2013.122013.12–2014.12
- U0073/94, U0120/96, U0123/62, U0124/95, U0126/63, U0293/592014.12–2015.112015.11–2017.06from 2017.06
- ABS Warning Light Remains ON2011.12–2014.122014.12–2015.11from 2015.11
- ABS Warning Light does not Come ON2011.12–2014.122014.12–2015.11from 2015.11
- Brake Warning Light Remains ON2011.12–2013.122013.12–2014.122014.12–2015.11from 2015.11
- Brake Warning Light does not Come ON2011.12–2014.122014.12–2015.11from 2015.11
- Brake Control Warning Light Remains ON2011.12–2014.122014.12–2015.11from 2015.11
- Brake Control Warning Light does not Come ON2011.12–2013.122013.12–2014.122014.12–2015.11from 2015.11
- Slip Indicator Light Remains ON2011.12–2014.122014.12–2015.11from 2015.11
- Slip Indicator Light does not Come ON2011.12–2013.122013.12–2014.122014.12–2015.11from 2015.11
- TC and CG Terminal Circuit2011.12–2014.122014.12–2015.112015.11–2018.08from 2018.08
- TS and CG Terminal Circuit2011.12–2014.122014.12–2015.112015.11–2018.08from 2018.08
- VSC OFF Switch Circuit2014.12–2015.11from 2015.11
FRONT SPEED SENSOR
REAR SPEED SENSOR
STEERING ANGLE SENSOR
BRAKE PEDAL STROKE SENSOR(for LHD)
BRAKE PEDAL STROKE SENSOR(for RHD)
VSC OFF SWITCH