Home › Brake › BRAKE SYSTEM (OTHER) › BRAKE PEDAL(for RHD) › from 2014.12
RM2170E _54 Brake _057022 BRAKE SYSTEM (OTHER) _0278028 BRAKE PEDAL(for RHD) A

BRAKE SYSTEM (OTHER)  BRAKE PEDAL(for RHD)  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 2.DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

Hide 55404D 3.REMOVE INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY

HINT:

Use the same procedure for LHD and RHD (See page Vehicle Interior>METER / GAUGE / DISPLAY>COMBINATION METER>REMOVAL).


Hide 84340 5.REMOVE STOP LIGHT SWITCH ASSEMBLY

Hide 84345 6.REMOVE STOP LIGHT SWITCH MOUNTING ADJUSTER

Hide 47101A 7.REMOVE BRAKE PEDAL RETURN SPRING

a.
C249827

Remove the brake pedal return spring from the brake pedal support assembly.


Hide 47264A 8.REMOVE PUSH ROD PIN

a.
C249828

Remove the clip and push rod pin.


b.

Separate the push rod clevis from the brake pedal support assembly.


Hide 9.REMOVE BRAKE PEDAL SUPPORT ASSEMBLY

a.
C249826

Remove the bolt and separate the brake pedal support assembly from the instrument panel reinforcement assembly.


b.

Disengage the clamp and separate the wire harness from the brake pedal support assembly.


c.
C249829

Disengage the wire harness clamp to separate it from the stud bolt of the brake booster with master cylinder assembly.


d.
C249830

Remove the 4 nuts and brake pedal support assembly.