Home › Brake › BRAKE (FRONT) › FRONT BRAKE › 2011.12–2014.12
RM2170E _54 Brake _057023 BRAKE (FRONT) _0278036 FRONT BRAKE A

BRAKE (FRONT)  FRONT BRAKE  REMOVAL  


CAUTION / NOTICE / HINT

NOTICE:
·

When the brake pedal is first depressed after replacing the brake pads or pushing back the disc brake piston, DTC C1214 may be output. As there is no malfunction, clear the DTC.

·

While the auxiliary battery is connected, even if the power switch is off, the brake control system activates when the brake pedal is depressed or the door courtesy switch is turned on. Therefore, even if only brake pads are to be removed and installed, be sure to perform the Disable Brake Control procedure and disconnect the cable from the negative (-) terminal of the auxiliary battery before beginning work.



HINT:
·

Use the same procedure for the LH side and RH side.

·

The following procedure is for the LH side.



PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 3.REMOVE FRONT WHEEL

Hide 4.DRAIN BRAKE FLUID

NOTICE:

If brake fluid leaks onto any painted surface, immediately clean it off.


Hide 47313J 5.SEPARATE FRONT FLEXIBLE HOSE

a.
C249580

Remove the union bolt and gasket, and separate the front flexible hose from the disc brake cylinder assembly.


Hide 47750 6.REMOVE DISC BRAKE CYLINDER ASSEMBLY

a.
C249581E02
1.063,1.125 1.24,1.281 0.177,0.156 10 false *a 1.063,0.427 1.229,0.583 0.167,0.156 10 false *b

Hold the front disc brake cylinder slide pin, and remove the 2 bolts and disc brake cylinder assembly.

Text in Illustration
*a Hold
*b Turn


Hide 04465 7.REMOVE FRONT DISC BRAKE PAD

a.
C249583

Remove the 2 front disc brake pads from the front disc brake cylinder mounting.


Hide 04945 8.REMOVE FRONT ANTI-SQUEAL SHIM KIT

a.
C256880E02
0.406,0.646 0.406,0.292 0.406,0.292 0.906,0.292 false 0.854,0.938 0.854,0.583 0.854,0.583 1.354,0.583 false 2.479,2.469 2.479,2.823 2.479,2.823 1.979,2.823 false 3.042,2.708 3.042,3.063 3.042,3.063 2.542,3.063 false 1.375,0.49 1.531,0.635 0.156,0.146 10 false *1 0.927,0.188 1.083,0.333 0.156,0.146 10 false *2 1.813,2.74 1.969,2.885 0.156,0.146 10 false *1 2.333,2.99 2.49,3.135 0.156,0.146 10 false *2

Remove the front No. 1 anti-squeal shim and front No. 2 anti-squeal shim from each front disc brake pad.

Text in Illustration
*1 Front No. 1 Anti-squeal Shim
*2 Front No. 2 Anti-squeal Shim


b.
C256881

Remove the pad wear indicator plate from each front disc brake pad.


Hide 04947 9.REMOVE FRONT DISC BRAKE FITTING KIT

a.
C249584E02
2.271,0.719 2.646,0.719 true 2.146,1.813 2.646,1.813 false 1.427,1.635 0.979,1.635 false 1.531,0.729 1.104,0.729 true 2.667,0.635 2.844,0.813 0.177,0.177 10 true *1 0.771,1.552 0.948,1.729 0.177,0.177 10 true *1 0.917,0.646 1.094,0.823 0.177,0.177 10 true *2 2.688,1.719 2.844,1.875 0.156,0.156 10 false *2

Remove the 2 front No. 1 disc brake pad support plates and 2 front No. 2 disc brake pad support plates from the front disc brake cylinder mounting.

Text in Illustration
*1 Front No. 1 Disc Brake Pad Support Plate
*2 Front No. 2 Disc Brake Pad Support Plate

NOTICE:

Each front disc brake pad support plate has a different shape. Be sure to put an identification mark on each front disc brake pad support plate so that it can be reinstalled to its original position.



Hide 10.REMOVE FRONT DISC BRAKE CYLINDER SLIDE PIN (for Lower Side)

a.
C249586

Remove the front disc brake cylinder slide pin from the front disc brake cylinder mounting.


Hide 47769 11.REMOVE FRONT DISC BRAKE CYLINDER SLIDE BUSHING

a.
C210924E13
2.552,0.909 2.715,1.072 0.163,0.163 10 *1 2.332,1.4 2.332,0.996 2.332,0.996 2.545,0.996 false

Using a screwdriver with its tip wrapped with vinyl tape, remove the front disc brake cylinder slide bushing from the front disc brake cylinder slide pin (for Lower Side).

Text in Illustration
*1 Vinyl Tape

NOTICE:

Do not damage the front disc brake cylinder slide pin (for Lower Side).



Hide 12.REMOVE FRONT DISC BRAKE CYLINDER SLIDE PIN (for Upper Side)

a.
C249587

Remove the front disc brake cylinder slide pin from the front disc brake cylinder mounting.


Hide 13.REMOVE FRONT DISC BRAKE BUSHING DUST BOOT

a.
C249588

Remove the 2 front disc brake bushing dust boots from the front disc brake cylinder mounting.


Hide 47722 14.REMOVE FRONT DISC BRAKE CYLINDER MOUNTING

a.
C249589

Remove the 2 bolts and front disc brake cylinder mounting from the steering knuckle.


Hide 43512 15.REMOVE FRONT DISC

a.
C249590E02
2.302,1.115 2.656,1.115 2.656,1.115 2.323,1.146 true 2.688,1.031 2.833,1.177 0.146,0.146 10 false *a

Remove the front disc.

Text in Illustration
*a Matchmark

HINT:

Put matchmarks on the disc and the axle hub.