If both the RH side hose and LH side hose are disconnected at the same time, be sure to place identification marks indicating the position on each side.
Use the same procedure for the LH side and RH side.
The following procedure listed is for the LH side.
1. PRECAUTION
After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).
2. DISABLE BRAKE CONTROL
3.REMOVE REAR WHEEL
4.DRAIN BRAKE FLUID
Immediately wash off any brake fluid that comes into contact with any painted surfaces.
58156
5.REMOVE FRONT NO. 4 FLOOR HEAT INSULATOR (for RH Side)
77606
6.REMOVE NO. 1 FUEL TANK PROTECTOR SUB-ASSEMBLY (for RH Side)
47319F
7.REMOVE REAR FLEXIBLE HOSE
Using a union nut wrench, disconnect the 2 brake lines while holding the rear flexible hose with a wrench.
Do not kink or damage the brake line.
Do not allow any foreign matter such as dirt and dust to enter the brake line.
Remove the 2 clips and rear flexible hose.