Use the same procedure for the No. 3 parking brake cable assembly and No. 2 parking brake cable assembly.
1.REMOVE REAR CONSOLE BOX ASSEMBLY
58995A
2.REMOVE NO. 1 CONSOLE BOX MOUNTING BRACKET
58997
3.REMOVE NO. 3 CONSOLE BOX MOUNTING BRACKET
4.LOOSEN LOCK NUT
Loosen the lock nut.
| *1 | Lock Nut |
If the lock nut has been removed from the rod, replace the lock nut with a new one.
46430
5.SEPARATE NO. 3 PARKING BRAKE CABLE ASSEMBLY
(See page Brake>BRAKE (REAR)>REAR BRAKE>REMOVAL)
58156
6.REMOVE FRONT NO. 4 FLOOR HEAT INSULATOR (for RH Side)
Remove the 2 nuts and front No. 4 floor heat insulator.
77606
7.REMOVE NO. 1 FUEL TANK PROTECTOR SUB-ASSEMBLY (for RH Side)
Remove the clip.
Remove the bolt and No. 1 fuel tank protector sub-assembly.
46430
8.REMOVE NO. 3 PARKING BRAKE CABLE ASSEMBLY
Disengage the 2 claws to remove the parking brake cable stopper.
Separate the No. 3 parking brake cable assembly from the parking brake equalizer.
| *1 | Parking Brake Equalizer |
| *2 | No. 2 Parking Brake Cable Assembly |
| *3 | No. 3 Parking Brake Cable Assembly |
Remove the bolt and separate the No. 3 parking brake cable assembly.
Remove clamp B from the body.
Remove the 4 bolts, disengage clamp A and remove the No. 3 parking brake cable assembly.
46420A
9.REMOVE NO. 1 PARKING BRAKE CABLE CLAMP
Disengage the 2 claws to remove the No. 1 parking brake cable clamp from the No. 3 parking brake cable assembly.