When the brake pedal is first depressed after replacing the brake shoes or pushing back the wheel brake cylinder piston, DTC C1214 may be output. As there is no malfunction, clear the DTC.
While the auxiliary battery is connected, even if the power switch is off, the brake control system activates when the brake pedal is depressed or the door courtesy switch is turned on. Therefore, even if only brake shoes are to be removed and installed, be sure to perform the Disable Brake Control procedure and disconnect the cable from the negative (-) terminal of the auxiliary battery before beginning work.
Use the same procedure for the LH side and RH side.
The following procedure is for the LH side.
1. PRECAUTION
After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).
2. DISABLE BRAKE CONTROL
3.REMOVE REAR WHEEL
4.DRAIN BRAKE FLUID
Immediately wash off any brake fluid that comes into contact with any painted surfaces.
5.LOOSEN LOCK NUT
42403
6.REMOVE REAR BRAKE DRUM SUB-ASSEMBLY
Release the parking brake and remove the rear brake drum.
|
Contract |
If the rear brake drum cannot be removed easily, perform the following procedure.
Remove the shoe adjusting hole plug and insert a screwdriver through the hole into the backing plate, and hold the automatic adjust lever away from the adjuster.
Using another screwdriver, contract the brake shoe by turning the adjusting bolt.
04943A
7.REMOVE REAR BRAKE STRUT KIT
Using SST, separate the tension spring from the rear brake shoe.
| *1 | Wheel Cylinder Boot |
| *2 | Tension Spring |
Do not damage the wheel cylinder boot.
Using SST, remove the 2 shoe hold down spring cups, shoe hold down spring, pin and rear brake shoe.
Remove the shoe tension spring.
Using SST, remove the 2 shoe hold down spring cups, shoe hold down spring, pin and rear brake shoe.
Remove the tension spring from the rear brake shoe and remove the rear brake strut kit.
46430
8.SEPARATE NO. 3 PARKING BRAKE CABLE ASSEMBLY
Using needle-nose pliers, separate the No. 3 parking brake cable assembly.
47644A
9.REMOVE REAR BRAKE AUTOMATIC ADJUST LEVER
Remove the rear brake automatic adjust lever tension spring and rear brake automatic adjust lever.
47548R
10.REMOVE REAR DRUM BRAKE BLEEDER PLUG CAP
47547R
11.REMOVE REAR DRUM BRAKE BLEEDER PLUG
47570
12.REMOVE REAR WHEEL BRAKE CYLINDER ASSEMBLY
Using a union nut wrench, disconnect the brake line from the rear brake wheel cylinder assembly.
Remove the 2 bolts and rear wheel brake cylinder assembly from the backing plate.