Home › Steering › POWER ASSIST SYSTEMS › POWER STEERING SYSTEM
RM2170E _55 Steering _057026 POWER ASSIST SYSTEMS _0278045 POWER STEERING SYSTEM U

POWER ASSIST SYSTEMS  POWER STEERING SYSTEM  TERMINALS OF ECU  


CHECK POWER STEERING ECU ASSEMBLY


U183537E02
1.698,2.083 1.906,2.25 0.208,0.167 10 false G6 2.385,2.083 2.552,2.25 0.167,0.167 10 false z7 3.438,2.083 3.604,2.25 0.167,0.167 10 false z8 4.865,2.094 5.125,2.26 0.26,0.167 10 false A33 0.219,0.094 0.375,0.271 0.156,0.177 10 false *a

Text in Illustration
*a Component without harness connected
(Power Steering ECU Assembly)
- -

a.

Measure the voltage and resistance according to the value(s) in the table below.

NOTICE:
·

Check if the power steering ECU assembly connectors are securely connected by pulling on them from the backside.

·

If the EPS warning light is illuminated due to a malfunction, the fail-safe function may cause the voltage of the power steering ECU's terminals to become 0 V.



Terminals No. (Symbol) Wiring Color Terminal Description Condition Specified Condition
G6-1 (IG) - Body ground L - Body ground IG power source Power switch on (IG) 9 to 16 V
G6-6 (TS) - Body ground G - Body ground Test mode signal Always 9 to 16 V
G6-7 (CANH) - G6-8 (CANL) LG - W CAN communication line Power switch off (lock) 54 to 69 Ω
z7-1 (TRQ2) - Body ground Y - Body ground Torque sensor 2 input signal Power switch on (ready), steering wheel not being turned (without load) 2.3 to 2.7 V
Power switch on (ready), steering wheel being turned to right 1.2 to 2.5 V
Power switch on (ready), steering wheel being turned to left 2.5 to 3.8 V
z7-2 (TRQG) - Body ground B - Body ground Torque sensor ground Always Below 1 Ω
z7-8 (TRQV) - Body ground R - Body ground Torque sensor power source Power switch on (ready) 4.5 to 5.5 V
z7-9 (TRQ1) - Body ground W - Body ground Torque sensor 1 input signal Power switch on (ready), steering wheel not being turned (without load) 2.3 to 2.7 V
Power switch on (ready), steering wheel being turned to right 2.5 to 3.8 V
Power switch on (ready), steering wheel being turned to left 1.2 to 2.5 V
z8-1 (M1) - Body ground R - Body ground Power steering motor assembly output signal 1 Power switch on (ready), steering wheel being turned to left 9 to 16 V
Power switch on (ready), steering wheel being turned to right 6 to 8 V
z8-2 (M2) - Body ground B - Body ground Power steering motor assembly output signal 2 Power switch on (ready), steering wheel being turned to left 6 to 8 V
Power switch on (ready), steering wheel being turned to right 9 to 16 V
A33-1 (PIG) - Body ground W - Body ground Power steering motor assembly power supply input signal Always 9 to 16 V
A33-2 (PGND) - Body ground W-B - Body ground Power ground Always Below 1 Ω

If the result is not as specified, the ECU may have a malfunction.