POWER ASSIST SYSTEMS
POWER STEERING SYSTEM
- PRECAUTION2011.12–2014.122014.12–2015.11from 2015.11
- PARTS LOCATION
- SYSTEM DIAGRAM2011.12–2014.12from 2014.12
- SYSTEM DESCRIPTION
- HOW TO PROCEED WITH TROUBLESHOOTING2011.12–2014.122014.12–2015.11from 2015.11
- CALIBRATION2011.12–2014.122014.12–2018.08from 2018.08
- PROBLEM SYMPTOMS TABLE2011.12–2013.122013.12–2014.122014.12–2015.112015.11–2018.08from 2018.08
- TERMINALS OF ECU
- DIAGNOSIS SYSTEM
- DTC CHECK / CLEAR2011.12–2018.08from 2018.08
- FREEZE FRAME DATA2011.12–2014.12from 2014.12
- FAIL-SAFE CHART
- DATA LIST / ACTIVE TEST2011.12–2014.12from 2014.12
- DIAGNOSTIC TROUBLE CODE CHART2011.12–2014.12from 2014.12
- ON-VEHICLE INSPECTION2011.12–2014.12from 2014.12
- C1511/11 Diagnosis Condition: IG ON Malfunction Status: TRQ1 voltage is less than 0.25 V or more than 4.6 V
- C1512/12 Diagnosis Condition: IG ON Malfunction Status: TRQ2 voltage is less than 0.25 V or more than 4.6 V
- C1513/13 Deviation of torque sensor TRQ1 and TRQ2 exceeds specified values
- C1514/14 Diagnosis Condition: IG ON Malfunction Status: TRQV voltage is less than 4.5 V or more than 5.5 V.
- C1515/15 This DTC is stored when torque sensor zero point calibration has not been performed.
- C1516/16 Torque sensor zero point calibration is incomplete due to the steering wheel being touched during calibration.
- C1517/17 Temporary control due to malfunction related to torque sensor continues for long time
- C1524/24, C1555/55
- C1531/31, C1532/32, C1533/33, C1534/34, C1535/35
- C1551/51 Open or short in IG power source circuit with power switch ON
- C1552/52, C1554/54
- C1553/53 · PIG power source overvoltage · IG power source overvoltage
- C1581/81 Assist map not written in power steering ECU assembly2011.12–2014.122014.12–2015.11from 2015.11
- C1582/82 Assist map number mismatch2011.12–2014.122014.12–2015.11from 2015.11
- U0129/93, U0293/922011.12–2014.12from 2014.12
- EPS Warning Light Circuit2011.12–2014.122014.12–2015.11from 2015.11
- TC and CG Terminal Circuit2011.12–2014.122014.12–2015.112015.11–2018.08from 2018.08
- TS and CG Terminal Circuit2011.12–2018.08from 2018.08
- Check Assist Limit Record from 2014.12