Home › Steering › POWER ASSIST SYSTEMS › POWER STEERING SYSTEM › 2011.12–2018.08
RM2170E _55 Steering _057026 POWER ASSIST SYSTEMS _0278045 POWER STEERING SYSTEM J

POWER ASSIST SYSTEMS  POWER STEERING SYSTEM  TS and CG Terminal Circuit  


DESCRIPTION

In Test Mode (signal check), a malfunction in a speed sensor that cannot be detected when the vehicle is stopped can be detected while driving.

Sensor check mode can be entered by connecting terminals TS and CG of the DLC3 and turning the power switch from off (lock) to on (ready).

WIRING DIAGRAM

C167369E45
0.457,2.93 0.674,3.088 0.217,0.157 10 G4 0.94,1.791 1.195,1.953 0.255,0.162 10 CG 0.954,0.909 1.209,1.071 0.255,0.162 10 TS 1.237,0.815 1.435,0.971 0.198,0.156 10 12 1.258,1.694 1.456,1.850 0.198,0.156 10 4 5.668,2.924 5.886,3.073 0.218,0.149 10 G6 6.029,0.906 6.230,1.055 0.201,0.149 10 TS 5.829,0.808 6.002,0.957 0.173,0.149 10 6 5.92,2.924 6.897,3.267 0.976,0.343 10 Power Steering ECU Assembly 0.709,2.93 1.095,3.088 0.386,0.157 10 DLC3

CAUTION / NOTICE / HINT

NOTICE:

If the power steering ECU assembly has been replaced with a new one, perform assist map writing and torque sensor zero point calibration (See page Steering>POWER ASSIST SYSTEMS>POWER STEERING SYSTEM>CALIBRATION).


PROCEDURE

1.CHECK HARNESS AND CONNECTOR (POWER STEERING ECU ASSEMBLY - TS of DLC3)
a.

Disconnect the power steering ECU assembly connector.


b.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
G6-6 (TS) - G4-12 (TS) Always Below 1 Ω
G6-6 (TS) - Body ground Always 10 kΩ or higher




OK

2.CHECK HARNESS AND CONNECTOR (CG of DLC3 - BODY GROUND)

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

2.CHECK HARNESS AND CONNECTOR (CG of DLC3 - BODY GROUND)
a.
U159337E01
0.275,0.249 0.459,0.419 0.184,0.170 10 *a 2.286,0.811 2.525,0.980 0.239,0.170 10 CG 0.322,1.039 0.534,1.190 0.212,0.151 10 G4 1.681,1.957 2.409,1.014 false

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
G4-4 (CG) - Body ground Always Below 1 Ω


Text in Illustration
*a Front view of DLC3



OK

REPLACE POWER STEERING ECU ASSEMBLY

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR