Home › Steering › STEERING COLUMN › STEERING WHEEL › 2011.12–2014.12
RM2170E _55 Steering _057027 STEERING COLUMN _0278048 STEERING WHEEL A

STEERING COLUMN  STEERING WHEEL  INSTALLATION  


PROCEDURE

Hide 45184 1.INSTALL LOWER STEERING WHEEL BOSS COVER

a.
C206252

Engage the 2 pins and 4 claws to install the lower steering wheel boss cover to the steering wheel sub-assembly.


Hide 84633 2.INSTALL CRUISE CONTROL SWITCH WIRE

Hide 84250A 4.INSTALL STEERING PAD SWITCH ASSEMBLY

Hide 5.ALIGN FRONT WHEELS FACING STRAIGHT AHEAD

Hide 84307 6.ADJUST SPIRAL CABLE WITH SENSOR SUB-ASSEMBLY

Hide 45100 7.INSTALL STEERING WHEEL ASSEMBLY

a.
C252595E01
0.453,0.438 0.617,0.589 0.164,0.151 10 *a 1.731,0.538 0.649,0.538 false 1.726,0.658 0.774,0.658 0.774,0.658 0.774,0.538 false

Align the matchmarks on the steering wheel assembly and steering main shaft to install the steering wheel assembly.

Text in Illustration
*a Matchmark


b.

Install the steering wheel assembly set nut.

Torque:
50 N*m (510 kgf*cm, 37 ft.*lbf)


c.

Connect the connectors to the spiral cable sub-assembly.


Hide 8.CHECK STEERING WHEEL CENTER POINT

Hide 45130 9.INSTALL HORN BUTTON ASSEMBLY