Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › STEERING PAD › 2011.12–2014.12
RM2170E _58 Vehicle Interior _057039 SUPPLEMENTAL RESTRAINT SYSTEMS _0278100 STEERING PAD A

SUPPLEMENTAL RESTRAINT SYSTEMS  STEERING PAD  INSTALLATION  


PROCEDURE

Hide 45130 1.INSTALL HORN BUTTON ASSEMBLY

a.

Check that the power switch is off.


b.

Check that the cable is disconnected from the negative (-) auxiliary battery terminal.

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.



c.
B312018E02
1.5,2.271 0.625,2.271 true 0.688,2.625 1.802,2.625 1.802,2.625 1.802,2.49 true 0.875,0.292 0.76,0.188 0.76,0.188 0.583,0.188 true 0.5,2.531 0.688,2.729 0.188,0.198 10 true *1 0.448,2.177 0.656,2.354 0.208,0.177 10 true *2 0.406,0.115 0.583,0.292 0.177,0.177 10 false *3

Connect the airbag connector to the horn button assembly.

Text in Illustration
*1 Airbag Connector
*2 Horn Connector
*3 Airbag Connector Lock

NOTICE:
·

When connecting any airbag connector, take care not to damage the airbag wire harness.

·

Be sure to only connect the connectors to each corresponding color.




d.

Push in the airbag connector lock to install the airbag connector.


e.

Connect the horn connector to the horn button assembly.


f.
B296302

Push the horn button assembly to engage the 2 pins carefully.

NOTICE:
·

Make sure that the pins are securely inserted into the steering holes.

·

Make sure that the horn button assembly is securely installed.




Hide 45187 2.INSTALL LOWER NO. 3 STEERING WHEEL COVER

a.

Engage the claw and guide to install the lower No. 3 steering wheel cover.


Hide 45186 3.INSTALL LOWER NO. 2 STEERING WHEEL COVER

a.

Engage the claw and guide to install the lower No. 2 steering wheel cover.


Hide 4.CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 45130 6.INSPECT HORN BUTTON ASSEMBLY

a.

Make sure that the horn sounds.

HINT:

If the horn does not sound, inspect the horn system (See page Vehicle Exterior>HORN>HORN SYSTEM>PROBLEM SYMPTOMS TABLE).