86101J
1.INSTALL NO. 2 ANTENNA CORD SUB-ASSEMBLY
Install the No. 2 antenna cord sub-assembly to the roof headlining assembly from the front of the vehicle.
| *1 | Tape | *2 | Marking Tape |
| *3 | Protrusion A | *4 | Edge |
| *a | Front | - | - |
Align the taped part of the antenna cable with the protrusion of the roof headlining, and apply tape to secure the cable to the headlining.
Put the pieces of tape back to the positions shown in the illustration in order to secure the antenna cord to the roof headlining assembly.
If the tape is no longer sticky, use other tape, such as packing tape, that has enough adhesion to secure the antenna cord to the roof headlining assembly.
For the right front corner of the roof headlining assembly, align the marking tape on the antenna cord with the protrusion A of the roof headlining, and wrap tape around the antenna cord and roof headlining assembly once or twice to securely hold them. (1)
For the right rear corner of the roof headlining assembly, align the marking tape on the antenna cord with the rear edge of the roof headlining, and secure the antenna cord to the roof headlining assembly with tape. (2)
If the entire length of the antenna cord does not fit, adjust the length by tucking in the cord at the area shown in the illustration. (3)
2.INSTALL ROOF HEADLINING ASSEMBLY
86101
3.INSTALL ANTENNA CORD SUB-ASSEMBLY
Engage the 5 clamps.
Install the antenna cord sub-assembly with the 2 bolts.
Connect each connector.
55840C
4.INSTALL NO. 6 HEATER TO REGISTER DUCT ASSEMBLY
5.INSTALL RADIO RECEIVER ASSEMBLY WITH BRACKET
6.INSTALL UPPER INSTRUMENT PANEL ASSEMBLY