Home › Audio / Visual / Telematics › AUDIO / VIDEO › NOISE FILTER › 2011.12–2013.12
RM2170E _56 Audio / Visual / Telematics _057029 AUDIO / VIDEO _0278059 NOISE FILTER A

AUDIO / VIDEO  NOISE FILTER  INSTALLATION  


PROCEDURE

Hide 86011R 1.INSTALL RADIO SETTING CONDENSER

a.
E226085

Engage the claw to install a new terminal cover to the wire harness.

NOTICE:
·

Make sure to hold the wire harness so that the crimping side of the terminal is facing up when installing the wire harness to the terminal cover.

·

Make sure not to bend the exposed wire when installing the wire harness to the terminal cover.

·

Do not use excessive force when inserting the wire harness into the terminal cover.

·

If the terminal cover has been deformed at installation, replace the terminal and terminal cover with new ones.




b.
E223710

Engage the 6 claws to install the 2 new terminal covers with wire harness to a new condenser.

NOTICE:
·

Do not use excessive force when inserting the terminal cover into the condenser.

·

If the terminal cover has been deformed at installation, replace the terminals, terminal covers and condenser with new ones.




c.
E226095

Engage the claw to insert the cover as shown in the illustration.


d.

Engage the clamp to temporarily install a new radio setting condenser with wire harness.


e.

Install the new radio setting condenser with the bolt.

Torque:
8.4 N*m (86 kgf*cm, 74 in.*lbf)


Hide 64740C 2.INSTALL DECK TRIM SIDE PANEL ASSEMBLY LH

Hide 81330 4.INSTALL NO. 1 LUGGAGE COMPARTMENT LIGHT ASSEMBLY

Hide 73370 5.CONNECT REAR SEAT 3 POINT TYPE OUTER BELT ASSEMBLY LH

Hide 64330D 7.INSTALL PACKAGE TRAY TRIM PANEL ASSEMBLY

Hide 64995 9.INSTALL DECK FLOOR BOX RH

HINT:

Use the same procedure as for the LH side.


Hide 62332A 11.CONNECT REAR DOOR OPENING TRIM WEATHERSTRIP LH

Hide 71960B 18.INSTALL REAR CENTER SEAT HEADREST ASSEMBLY

Hide 71940A 19.INSTALL REAR SEAT HEADREST ASSEMBLY