71940A
1.REMOVE REAR SEAT HEADREST ASSEMBLY
71960B
2.REMOVE REAR CENTER SEAT HEADREST ASSEMBLY
58165F
3.REMOVE FRONT FLOOR COVER RH
58166B
4.REMOVE FRONT FLOOR COVER LH
58167H
5.REMOVE FRONT CENTER FLOOR COVER
6.REMOVE REAR SEATBACK ASSEMBLY LH
7.REMOVE REAR SEAT CUSHION ASSEMBLY
67918A
8.REMOVE REAR DOOR SCUFF PLATE LH
62332A
9.DISCONNECT REAR DOOR OPENING TRIM WEATHERSTRIP LH
58410B
10.REMOVE DECK BOARD ASSEMBLY
64997
11.REMOVE DECK FLOOR BOX LH
64995
12.REMOVE DECK FLOOR BOX RH
Use the same procedure as for the LH side.
64330D
13.REMOVE PACKAGE TRAY TRIM PANEL ASSEMBLY
64716D
14.REMOVE REAR DECK TRIM COVER
73370
15.DISCONNECT REAR SEAT 3 POINT TYPE OUTER BELT ASSEMBLY LH
58732C
16.REMOVE REAR ABSORBER CAP LH
81330
17.REMOVE NO. 1 LUGGAGE COMPARTMENT LIGHT ASSEMBLY
64740C
18.REMOVE DECK TRIM SIDE PANEL ASSEMBLY LH
86011R
19.REMOVE RADIO SETTING CONDENSER
When the terminal covers are removed, the radio setting condenser must be replaced because the terminal covers and condenser are supplied as a set.
Remove the bolt.
Disengage the clamp and disconnect the radio setting condenser with wire harness from the vehicle body.
Disengage the claw and pull out the cover as shown in the illustration.
Using a screwdriver, disengage the 6 claws and remove the 2 terminal covers with wire harness from the condenser.
Using a screwdriver, bend back and break off the claw as shown in the illustration.
Remove the terminal cover from the wire harness.
Make sure to hold the wire harness on the crimping side of the terminal when disconnecting the wire harness from the terminal cover.
Make sure not to bend the exposed wire when disconnecting the wire harness from the terminal cover.
Check for deformation of the terminal after the wire harness has been removed from the terminal cover.